Properly setting up your wing is essential for a safe and enjoyable flight with your flying inflatable boat. Follow these step-by-step instructions to ensure your wing is correctly set up.
- Unzip Wing Bag Start by unzipping the wing bag completely to access the wing. Ensure the bag is placed on a flat and clean surface to prevent any damage to the wing.
- Set Up Control Bar Assemble the control bar according to the manufacturer’s instructions. This will be the main interface for controlling your wing during flight.
- Flip Wing Around 180 Degrees Carefully flip the wing around 180 degrees. This helps in properly aligning the components and preparing for the next steps.
- Open One Side of Wing to Full Extend Extend one side of the wing fully. This will make it easier to attach and align the king post fitting.
- Attach King Post Fitting to King Post Secure the king post fitting to the king post. Ensure it is firmly attached as this is a critical part of the wing’s structure.
- Open Other Side of Wing to Full Extend Extend the other side of the wing fully. This completes the basic setup and alignment of the wing.
- Put in All Wing Battens Insert all the wing battens into their respective pockets. This will provide the necessary shape and rigidity to the wing.
- Attach Pulley System in Middle of Wing Attach the pulley system in the middle of the wing using one pin. This system puts tension in the wing, which is crucial for its aerodynamic properties.
- Lift Wing Up, Resting on the Control Bar Carefully lift the wing and rest it on the control bar. This position will allow you to attach the front lines to the wing easily.
- Preflight Wing Inspection Perform a thorough preflight inspection of the wing. Check all connections, fittings, and fabric for any signs of wear or damage. This step is very important and should not be skipped.
- Bring Wing to Boat Always Facing Into the Wind When transporting the wing to the boat, always ensure it is facing into the wind. This helps in controlling the wing and prevents damage. The wing should go under the bar for safety.
- Attach Top Big Bolt Secure the top big bolt to the wing. Ensure it is tightly fastened.
- Attach Front Bolt Attach the front bolt to secure the front of the wing. Double-check that it is firmly in place.
- Attach Jesus Strap The Jesus strap is a crucial safety feature. Attach it securely to the designated points on the wing.
- Attach Side Control Lines Finally, attach the side control lines. These lines will help in controlling the wing during flight.
The entire setup process should take about 15-20 minutes. Once everything is securely attached and you’ve performed a thorough inspection, you’re ready to fly!
Main Conclusion
Setting up your wing properly is essential for a safe and successful flight. By following these detailed instructions, you can ensure that your wing is correctly assembled and ready for use. Always remember to perform a thorough preflight inspection to catch any potential issues before they become problems. Happy flying!
